CLEAN BURN CB-1800 Manuel de l'opérateur télécharger pdf (Page 34)

Operator's Manual: Models CB-3500 & CB-5000

3-14

Installing the Connector Block, Oil Line Tubing, and Air Line Tubing (continued)

Installing the Oil Line Tubing (continued)

5. Make sure that the curl in the oil line is positioned as shown in Figure 3I so that the burner can swing

open correctly.

6. Install the oil line tubing and tighten the nuts on the compression ttings. DO NOT overtighten these

ttings to avoid damaging the ferrules.

NOTE: You may also check the positioning of the oil line according to Figure 3J, which provides a larger front

view of the connector block assembly.

Installing the Air Line Tubing

1. Remove and discard the red caps from the air line tubing.

2. Refer to Figure 3J. Push the air line tubing into the swivel tting on the connector block until

the tubing bottoms out in the tting.

3. Repeat this procedure to connect the air line tubing to the air line tting on the side of the burner.

Figure 3J - Installation of Connector Block, Oil Line, and Air Line (Front View)

I88357-A

OIL LINE

AIR LINE

OIL LINE FITTING

ON BURNER

AIR LINE FITTING

ON BURNER

COMPRESSION

FITTING

SWIVEL

FITTING

CONNECTOR BLOCK

WITH ACCUMULATOR

INSTALLED ON

FURNACE CABINET

AIR OIL

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 133 134

Pas de commentaire

CLEAN BURN CB-1800 Manuel de l'opérateur Page 34